Corrigendum to “Active subspaces for the optimal meanline design of unconventional turbomachinery” (Applied Thermal Engineering (2017) 127 (1108–1118), (S1359431117315466) (10.1016/j.applthermaleng.2017.08.093))

By means of this corrigendum, the authors would like to include relevant information regarding the validation of the meanline turbine model employed in the original article. The improvement regarding the validation of the model was made possible thanks to the contribution of Prof. Jürg Schiffmann. The additional results documented here provide more confidence on the reliability of the model when it applied to mini-ORC turbines. Therefore, we kindly ask the Editor to add his name to the authors list. The following paragraph extends the one that discusses the meanline validation located in Section 2. The turbine preliminary design is performed by means of a meanline code, which is based on the loss models listed in Ref. [1]. These models have been developed for conventional turbomachinery operating with fluids in the ideal gas state, featuring subsonic flows and large Reynolds numbers. The meanline code has been validated with the results of literature test cases presenting these characteristics [2]. It has been also compared against an experimentally validated turbine model for mORC machines operating in the subsonic regime [3]. Table 1 shows the information of the machine geometry for which results of the two codes were compared, while Fig. 1 presents the meridional channel of the turbine. Table 2 shows the corresponding operating conditions. The results of the total-to-static efficiency computation are presented in Fig. 2. It can be observed that the efficiency trend obtained with zTurbo is similar to that computed with the validated EPFL code. The comparison between the two models suggests a deviation lower than 2.5% for all the tested operating conditions. This deviation occurs because each model uses a different set of loss correlations. These correlations are described in Refs. [1,3].