Injectivity of Multiple Slugs in Surfactant Alternating Gas Foam EOR: A CT Scan Study

Jiakun Gong, Sebastien Vincent-Bonnieu, Ridhwan Z. Kamarul Bahrim, Che A.N.B. Mamat, Raj D. Tewari, Mohammad I. Mahamad Amir, Jeroen Groenenboom, Rouhi Farajzadeh, William R. Rossen

Research output: Contribution to journalArticleScientificpeer-review

7 Citations (Scopus)
16 Downloads (Pure)

Abstract

A surfactant alternating gas (SAG) process is often the injection method for foam, on the basis of its improved injectivity over direct foam injection. In a previous study, we reported coreflood experiments on liquid injectivity after foam flooding and liquid injectivity after injection of a gas slug following steady-state foam. Results showed that a period of gas injection is important for the subsequent liquid injectivity. However, the effects of multiple gas and liquid slugs were not explored. In this paper, we present a coreflood study of injectivities of multiple gas and liquid slugs in an SAG process in a field core. Nitrogen and surfactant solution are either coinjected or injected separately into the sandstone core sample. The experiments are conducted at an elevated temperature of 90℃ with a backpressure of 40 bar. Differential pressures are measured to quantify gas and liquid injectivities. Computed tomography (CT) scanning is applied to relate water saturation to mobility. During the injection of a large gas slug following foam, a bank in which foam completely collapses or greatly weakens forms near the inlet and propagates slowly downstream. During the subsequent period of liquid injection, liquid flows through the collapsed-foam bank much more easily than further downstream. Beyond the collapsed-foam region, liquid first imbibes into the whole cross section. In this region, liquid flows mainly through a finger of high liquid saturation. Our CT results suggest a revision of our earlier interpretation; the process of gas dissolution does not merely follow fingering but is evidently directly involved in the fingering process. Our results suggest that, in radial flow, the small region of foam collapse very near the well greatly improves injectivity. The subsequent gas and liquid slugs behave near the wellbore, affecting injectivity, in a way similar to the first slugs. Thus, the behavior and modeling of the first gas slug and first subsequent liquid slug is representative of near-well behavior in an SAG process. The trends observed in our previous work are reproduced in a low-permeability field core.

Original languageEnglish
Pages (from-to)895-906
Number of pages12
JournalSPE Journal
Volume25
Issue number2
DOIs
Publication statusPublished - 2020

Bibliographical note

Green Open Access added to TU Delft Institutional Repository ‘You share, we take care!’ – Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.

Fingerprint

Dive into the research topics of 'Injectivity of Multiple Slugs in Surfactant Alternating Gas Foam EOR: A CT Scan Study'. Together they form a unique fingerprint.

Cite this