Documents

DOI

To investigate the effects of viscosity-modifying admixture (VMA) on the extrudability of limestone and calcined clay-based cementitious materials, three mix designs with different dosages of VMA were proposed in this study. The ram extrusion was utilized as an extrusion model for exploring the fresh properties of printable materials. Two methods were used, based on the ram extruder setup—(a) extruding materials with the same extrusion speed at different rest times to determine how the pressure changes with time; (b) extruding materials with different extrusion speeds at the same rest time to investigate the material flow parameters using the Basterfield et al. model. The main findings of this study could be summarized as—(1) the extrusion pressure of all mix designs exhibited an increasing trend with time. At the same tested age, the extrusion pressure under 0.25 mm/s of piston speed was increased and the shape retention of the extruded filaments was enhanced by increasing the dosage of VMA; (2) the correlation between the experimental results and the Basterfield et al. model was excellent (R-squared value: 0.99). The mixture with a higher content of VMA showed an increased elongational yield stress, flow consistency, and shear yield stress.
Original languageEnglish
Article number1374
Number of pages16
JournalMaterials
Volume12
Issue number9
DOIs
Publication statusPublished - 2019

    Research areas

  • Extrudability, Extrusion-based 3D concrete printing, Limestone and calcined clay, Ram extruder, Viscosity-modifying admixture

ID: 53672401